Carbon Brush For My3015-2.my3016-2.my3025

Features

• Genuine Tork Craft spare part for MY3015-2, MY3016-2 and MY3025.
• Carbon brush set matched to the original motor design.
• Pre-terminated brush leads for straightforward installation.
• Engineered to maintain stable electrical contact under load.
• Suitable for stainless burnishing and pipe/tube polishing applications.
• Compact spare that is easy to keep in stock for maintenance downtime.

Benefits

• Restores lost power and reduces “start–stop” behaviour on tired machines.
• Helps limit excessive sparking, protecting the commutator and motor.
• Reduces the risk of unexpected tool failure on site or in the workshop.
• Keeps specialised polishing machines earning money for longer.
• Correct fitment gives peace of mind compared to generic brush sets.

Extra Information

Typical signs that your carbon brushes are due for replacement include reduced power, heavy sparking through the vent slots, a burning smell or a machine that only runs when the cable is moved. This MY-CARB carbon brush spare has been chosen to match the motors used in the MY3015-2 stainless burnishing machine, MY3016-2 stainless pipe polisher and MY3025 tube belt sander, helping you keep an aligned, brand-correct maintenance programme on your polishing line-up.

Whenever you service these machines, it is good practice to inspect the brushes, commutator surface and cable condition at the same time. Using genuine spares supports long-term reliability and makes future troubleshooting much easier for technicians.

Pro Tip

Pro Tip: Always replace carbon brushes as a pair on the same machine, even if only one looks worn. After installation, run the polisher or tube belt sander with a light load for a short period to let the new brushes bed in properly against the commutator. Make a note of the service date on the machine so you can plan future preventative maintenance rather than waiting for a breakdown.

Specifications

Safety

• Always disconnect the machine from the mains supply before opening any covers or working on the motor.
• Allow the tool to cool down completely before handling internal components.
• Only use the correct MY-CARB carbon brush spare on the specified Tork Craft models.
• Ensure all covers, screws and guards are properly refitted before switching the machine on.
• If you are unsure about electrical repairs, consult a qualified technician or approved service centre.